Imagen de Portada

LiDAR-based Odometry Estimation Using Wheel Speed and Vehicle Model for Autonomous Buses

Guardado en:
Publicado en:International Journal of Control, Automation, and Systems vol. 23, no. 1 (Jan 2025), p. 41
Autor principal: Kwon, Woojin
Otros Autores: Lee, Hyunsung, Kim, Ayoung, Yi, Kyongsu
Publicado:
Springer Nature B.V.
Materias:
Transformations (mathematics)
Simultaneous localization and mapping
Urban environments
Odometers
Unmanned aerial vehicles
Trajectories
Kinematics
Drift estimation
Random noise
Algorithms
Pose estimation
Inertial platforms
Lidar
Inertial sensing devices
Robustness
Global navigation satellite system
Vehicles
Position errors
Acceso en línea:Citation/Abstract
Full Text - PDF
Etiquetas: Agregar Etiqueta
Sin Etiquetas, Sea el primero en etiquetar este registro!
Resumen:Simultaneous localization and mapping (SLAM) algorithms have been researched to achieve precise pose estimation for autonomous vehicles for several years. However, the target platforms in these studies have primarily focused on small ground vehicles and unmanned aerial vehicles (UAVs). Consequently, this paper proposes an improved LiDAR-based odometry estimation method for autonomous buses in urban environments, addressing a research gap often observed in the focus on predominant smaller platforms. Many SLAM algorithms have adopted the LiDAR-inertial odometry (LIO) method that uses inertial measurement unit (IMU) sensors to enhance accuracy. However, due to its heightened sensitivity to external conditions, the application of IMU on a substantial-size bus is considered impractical. Consequently, this study leverages the vehicle kinematics model and chassis information, including wheel speed, to estimate velocity and yaw rate, thereby improving the robustness and accuracy in comparison to the referenced LiDAR odometry method. Subsequently, the LiDAR map in the local frame undergoes transformation to the world frame by aligning the global navigation satellite system (GNSS) trajectory with the LiDAR SLAM trajectory. The study presents results based on actual vehicle data collected on urban tracks. Additionally, a non-Gaussian noise model was used for intentional GNSS corruption to validate the robustness of alignment methods. Experimental results demonstrate the mitigation of fault estimation and drift observed in the conventional LIO method. In the world transformation of a LiDAR map, the proposed matching methods yield robust results that closely approximate the desired transformation, even in the presence of GNSS position errors.
ISSN:1598-6446
2005-4092
DOI:10.1007/s12555-024-0003-4
Fuente:ABI/INFORM Global