Obálka

Physics-Based Predictive Modeling of Gravity-Induced Sagging in Support-Free Pellet Additive Manufacturing

Uloženo v:
Vydáno v:Polymers vol. 17, no. 21 (2025), p. 2858-2877
Hlavní autor: Pricci Alessio
Vydáno:
MDPI AG
Témata:
Finite element method
Printers (data processing)
Gravity
Extrusion rate
Viscosity
Investigations
Temperature dependence
Material properties
Rheology
Prediction models
Numerical models
Pellets
Process controls
Solidification
3-D printers
Polylactic acid
Three dimensional printing
Manufacturing
Minimum flow
Heat conductivity
Additive manufacturing
Process parameters
Cooling
Deflection
On-line přístup:Citation/Abstract
Full Text + Graphics
Full Text - PDF
Tagy: Přidat tag
Žádné tagy, Buďte první, kdo vytvoří štítek k tomuto záznamu!
Abstrakt:The fabrication of support-free structures in pellet additive manufacturing (PAM) is severely limited by gravity-induced sagging, a phenomenon lacking predictive, physics-based models. This study introduces and validates a numerical model for the thermofluid dynamics of sagging, aiming to correlate process parameters with filament deflection. A predictive finite element (FE) model incorporating temperature-dependent non-Newtonian material properties and heat transfer dynamics has been developed. This was validated via a systematic experimental study on a desktop-scale PAM 3D printer investigating nozzle temperature, printhead speed, screw speed and fan cooling, using polylactic acid (PLA) as a printing material. Findings show that process parameter optimization can reduce bridge deflection by 64.91%, with active fan cooling being the most dominant factor due to accelerated solidification. Increased printhead speed reduced sagging, whereas higher screw speeds and extrusion temperature showed the opposite effect. The FE model accurately replicated these results and further revealed that sagging ceases once the filament cools below its minimum flow temperature (approximately 150–160 °C for PLA). This validated model provides a robust foundation for tuning process parameters, unlocking effective support-free 3D printing in PAM.
ISSN:2073-4360
DOI:10.3390/polym17212858
Zdroj:Materials Science Database